Eagle Mach 1 Especificaciones descargar pdf (Pagina 9)

Adjustable Wood Tripod (AWT000)

Open the legs of the tripod at the desired observing location. Note which direction is

north (south if you are below the equator).

1. Position the tripod with one of the legs pointing roughly toward or away from

your pole.

2. Attach the shelf to each of the three legs with the knobs provided.

3. Adjust legs to the desired height and spread them fully.

4. Lock in position with the hand knobs and make sure that leg clamps are tight.

Note: Your tripod must be equipped with the Tripod Adapter (ADATRI) to mount the

Mach1GTO. If you purchased your tripod from Astro-Physics, it came with this adapter

already installed.

Adjustable Aluminum Tripod (SDS400)

Loosen the clamp on the support and spread the legs to the desired

position. Extend the legs to the desired height and clamp everything

tightly. Point one of the legs toward the north (or south) pole.

Note: The Adjustable Aluminum Tripod is not suitable for the heavier loads that the Mach1GTO can

carry. It is usable for setups with total instrument weight of less than 20 lbs. or if portability is of critical

importance. Also, see the note above regarding the Tripod Adapter (ADATRI).

6” Eagle Adjustable Folding Pier

Assembly instructions for the 6” Eagle Adjustable Folding

Pier are included with the pier. Please refer to those

instructions for assembly, adjustment and leveling

procedures. Your Mach1GTO will fit into the 6” Eagle

Adjustable Folding Pier without any additional adapters.

Simply set the mount into the open top of the pier and attach

with the three P

IER

ADAPTER KNOBS

included with the

mount.

Tripod Adapter

If you have your own custom pier or tripod with a flat surface on top, you can use our

Tripod Adapter (ADATRI) for mounting the Mach1GTO. We also offer a separate

adapter that can be used in conjunction with this Tripod Adapter to attach to a

Losmandy Heavy Duty Tripod or a Losmandy Meade Tripod Adapter (LT2APM).

See the website for deta

ils.

Attach the Mount to the Pier Post or Tripod

The PIER ADAPTER is already attached to your Mach1GTO. Starting in 2008, there are six attachment holes in the PIER

ADAPTER base for positioning flexibility. You, of course, only use three of them (every 120°) with the three provided PIER

ADAPTER KNOBS. Remove the three PIER ADAPTER KNOBS from the PIER ADAPTER. Simply set the mount into the pier post on

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 32 33

Sin comentarios

Eagle Mach 1 Especificaciones Pagina 9