Eagle E-DVR-104 Manual de instrucciones descargar pdf (Pagina 14)

User’s Manual

Connector Pin Outs:

Master Unit Slave Unit

RX  To  TXD

TX  To  RXD

GND  To  GND

NOTE: Refer to the following for pin-out details for the 9-pin connector of the slave unit.

Male

Female

Pin 2

RXD (Receive Data)

Pin 3

TXD (Transmit Data)

Pin 5

GND (Ground)

Power Cord Connector

Connect the connector from the adaptor to the DVR, and connect the AC power cord

to the adaptor and then to the wall outlet.

WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD.

MAKE CERTAIN THE POWER CORD WILL NOT BE PINCHED OR ABRADED BY

FURNITURE. DO NOT INSTALL POWER CORDS UNDER RUGS OR CARPET.

THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER OUTLET DOES NOT

HAVE A GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE PLUG. DO NOT

OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY DEVICES IN TO ONE CIRCUIT

CAUTION: Ensure the DVR is not near any heat source that could cause overheating.

CAUTION: The DVR does not have an internal fan so leave a clearance of at least 6

inches near ventilation hole areas on each side panel of the unit for proper ventilation.

Your DVR is now ready to operate. Refer to Chapter 3  Configuration and Chapter 4  Operation.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 91 92

Sin comentarios

Eagle E-DVR-104 Manual de instrucciones Pagina 14